Vintage Racer Group Forums
https://forum.vrgonline.org/

MAE Ford rods, 105E Anglia cyl head, oil pans, Kent/pre-cros
https://forum.vrgonline.org/viewtopic.php?f=6&t=605
Page 1 of 1

Author:  Jay Bee [ Wed Oct 04, 2017 5:02 pm ]
Post subject:  MAE Ford rods, 105E Anglia cyl head, oil pans, Kent/pre-cros

Rods used in MAE /Juniors
no cap bolts. Magged . Six of Cosworth, and two of Holbay. 4.611" + .125' long (standard MAE).
Very good condition, cleaned. Have been resting since the early 70's in cosmoline......all for $275

105E pre-crosflow cylinder head , removed from running motor, all stock valves/ springs, not molested ready for the porter for a 1 liter Ford or MAE. $175

Flywheel, steel 8" diameter 6 bolt 2 dowel 9 1/16" overall dia with 90 tooth ring gear. For MAE or lay over Kent/pre-crossflow. Face cut for 7 1/4" 0.t. clutch. 6.5 pounds. VGCondition $200.

Valve cover CHROME , Kent/pre-crossflow. Very nice no dents. 1 1/2" tube on top for fill/vent. $50

2 each oil pans. Wet sump pre-crossflow early motors with 2 piece rear main rope seal. One has a vertical baffle , the other has no baffle. Good parts . $60 each or both for $95.

I have pix but am not conversant to use them here..I'll try. CONTACT oneandout@att.net. Add shipping from So. Cal.

Attachments:
MAE RODS and PreOil Pan 003.JPG
MAE RODS and PreOil Pan 003.JPG [ 145.09 KiB | Viewed 1151 times ]
MAE RODS and PreOil Pan 002.JPG
MAE RODS and PreOil Pan 002.JPG [ 142.08 KiB | Viewed 1151 times ]

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/