|Vintage Racer Group Forums
|Formula Ford and BT21 Parts
|Page 1 of 1|
|Author:||bb2 [ Mon Mar 14, 2016 10:16 am ]|
|Post subject:||Formula Ford and BT21 Parts|
Auto Meter 3586 Sport-Comp Electric Ampmeter Gauge
New in Box
Chrome Race Bullet Outside Sports Mirrors
$48.67 non negotiable!
NEW IN BOX/BAGS
F3/OT-2 Clutch Disc, 7.25", 7/8x20 Spline, FF/SV
This sintered metallic clutch disc fits the Tilton OT-II, AP F3, and Quarter Master 7 1/4" racing clutches. The 7/8" x 20 spline is normally used on Super Vee and Formula Ford 1600 applications, but cars converted from FC to FF (such as Swift and Van Diemen) may still use the 1" x 23 spline from the 2.0L engine. Not for use with stock Ford clutch or on street-driven applications.
Tilton's minimum recommended clutch disc thickness is 0.074" in single-disc clutches or 0.089" on dual disc clutches. New clutch discs measure 0.104" thick.
NEW IN BOX
Tilton OT-2 Clutch, 7.25", Buff Spring FF1600
The Tilton OT-II Single Disc Clutch is a very high-quality open style 7 1/4" diameter racing clutch. The aluminum cover is much lighter and stiffer than the stamped steel cover used on many other clutches. The 7 1/4" diameter gives longer disc life than a 5.5" clutch at the expense of a little rotating inertia. This assembly includes the cover and pressure plate.
The Buff spring is a low-strength spring, recommended for Formula Ford and other cars producing up to 200 lb-ft of torque.
Racing clutches require high pedal force to actuate -- cable operated release mechanisms may not work. This clutch is appropriate for use with an external slave cylinder.
SMITHS Oil Pressure Gauge 0-100 PSF
Reasonably good condition for possible age. Operation ability is unknown.
Brabham BT 21
Formula car Bodywork panels…
One piece Fiberglas top with light smoke gray windscreen and satin finished bullet style side mirrors.
There is a heavy wire mesh screen mounted in the front of the air opening.
The paint finish is very nice as a Metallic Blue with White stripe and pinstripe outline. Number 2 stickers and FF stickers currently on the fiberglas and aluminum side panels. Removal would not be tough at all to replace with another #.
Two under panels as Left & Right sides roll-formed aluminum with mounted channels that receive the bottom of the top fiberglass section. Dsus fittings and Terry bolts/hold downs are attached. There would have to be the wire receiving sections of the Dsus fittings mounted to the chassis for the under panels to then attach for complete set up.
Great condition for being used.
THREE Lugnuts sets
3/8” diameter and 24 thread…
SET 1 is Used as 16 complete closed end hex heads.
SET 2 is New as 16 complete closed end hex heads.
SET 3 is New as 16 complete open end hex heads.
$20.00 for USED & $35.00 for NEW
Brion Farmer email@example.com
|Page 1 of 1||All times are UTC - 5 hours [ DST ]|
|Powered by phpBB® Forum Software © phpBB Group